
- Type : Solid State
- Configuration Dual-Mono / Fully Balanced
- Power Supply Transformers 2 x 10VA (audio); 1 x 10VA (controller)
- Power Supply Capacitance 44,000
- Circuit Topology Open Loop
- Balanced Inputs (XLR) 2 Pairs
- Single-ended inputs (RCA) 4 pairs
- Input Impedance 22,000 Ohms
- Input Sensitivity 200mV - 4.0V RMS
- Monitor Loop 1
- Balanced Outputs (XLR) 1 Pair
- Single-ended Outputs (RCA) 2 Pairs (variable & fixed)
- Output Impedance 50 Ohms
- Volume Steps 1 dB from 0-30 and 0.5dB from 30-80
- Gain control M-eVOL (R-2R)
- Gain 9dB
- Signal-to-noise Ratio (20Hz - 20KHz) 115dB
- Maximum Output Voltage - XLR 12 Volts
- Maximum Output Voltage - RCA 6 Volts
- Frequency Response 5Hz - 100KHz (+0 / -0.1dB)
- Crosstalk @ 1KHz - 115dB
- IMD unmeasurable
- THD (20Hz - 20KHz) 0.002%
- 12 Volt Trigger Output Operation
- Direct Logic (0V = off, 12V = on) Using a 3.5mm Mono microphone jack
with an input impedance of 1000 Ohms and current requirement of 12mA
- Simlink Port 1 input + 1 output each on 1/8' mini-jack
- RS-232 Port 9-pin Female DB connector
- IR input 1/8' mini-jack
- Remote Control All-Aluminum Full Function
- Display Type 8 character dot matrix LED
- Power Consumption @ idle 20 Watts
- Fuse Replacement - 230V 0.5A short slow blow
- Dimension - Preamp (W x H x D) 18.75 x 4 x 16.5 in.
- Dimension - Controller / Power Supply 18.75 x 5.5 x 16.5 in.
- Shipping Weight 40 lbs / 18 Kgs
|
|
|
19,000,000¿ø
|
8,580,000¿ø
|
12,000,000¿ø
|
14,500,000¿ø
|
|